GATE - NanoHARD™ AEG Controller (для страйкболу)

Розміри: uniwersalny

NanoHARD is a multifunction programmable AEG Controller. It has 8 functions. This is the first controller that provides you with possibility to turn off Active Brake. You can enable or disable the Active Brake at any time.

Battery protection supports: Li-Po 7.4 V / 11.1 V / 14.8 V. You can also disable the protection and use other batteries. Thanks to its special конформних coating, it is resistant to atmospheric conditions (Military Specification MIL-V-173C).

Functions:

ON/OFF ACTIVE BRAKE
This is the first controller that provides you with the possibility to turn off the Active Brake. You can enable or disable the Active Brake at any time.

SMART FUSE
The new AEG Controller should never let you down on the battle field. It is the best electronic fuse that has ever been made. This is the first AEG Controller with a true current sensor. A combination of current, voltage and temperature measurements provides your AEG installation with the high reliability. If your rifle becomes jammed, it protects motor battery and against any damage. There is known way to destroy the controller by overheating, overloading or short-circuiting of the electrical system.

BUILT-IN SELF-TEST
It allows you to quickly check whether the AEG Controller works properly. If you have problems with your AEG, the BUILT-IN SELF-TEST allows you to check that the problem is not caused by the controller.

MOSFET
Do you want to achieve higher rate of fire and faster trigger response? Are you planning power upgrade of your rifle? In that case, you need a MOSFET. It targets the energy from the battery directly to the motor, bypassing the mechanical trigger contacts. As a result, you gain a higher rate of fire of the rifle faster and trigger response, and the contacts are protected against burn out.

Protection against Over-Discharge of Battery
Modern LiPoly batteries are very sensitive to over-discharge. If you do not want to damage the battery and you care about its service life, this protection is indispensable. The microprocessor constantly monitors the battery voltage. When it drops down to a critical level, it will not permit firing.

DEBOUNCING
This provides full compatibility with the micro-switches. It is fully resistant to contact bounce. You gain a bigger ROF, a faster trigger response and your MOSFET is less prone to heating.

3rd Generation MOSFET
The usage of modern transistors and microcontroller has enabled us to create the smallest and most reliable AEG Controller in the market.

14.8V LI-PO READY
The system can be used with batteries up to LI-PO 14.8V. Minimum operating voltage is 3V and maximum voltage is 17V.

COATING
Thanks to its special coating, it is resistant to atmospheric conditions (Military Specification MIL-V-173C).

Included in the kit:
- NanoHARD™
- Additional kit of Deans-T Connectors
- Single signal wire for trigger contacts
- Double signal wire for trigger contacts
- Programming button
- Jumper (2pcs.)

User Guide